friction

常见例句

用作名词 (n.)

• Friction generates heat.
  摩擦生热。
• Oil can reduce friction.
  润滑油能减小摩擦力。
• When Joan returned to work, the friction between them increased.
  琼回来工作后,他们之间的摩擦加剧了。
• Family frictions can interfere with a child's schoolwork.
  家庭中的争吵会影响孩子的学业。

更多例句

• The pistons are graphite-coated to reduce friction.
  活塞上涂了一层石墨以减小摩擦力。
• the coefficient of friction
  摩擦系数
• When Joan returned to work, the friction between them increased.
  琼回来工作后, 他们之间的摩擦加剧了.
• the coefficient of friction
  摩擦系数
• Friction between moving parts had caused the engine to overheat.
  活动部件的摩擦使发动机过热。
• The friction of the sheets against his skin was torture.
  被单摩擦着他的皮肤，简直像是酷刑。
• Oil can reduce friction.
  润滑油能减小摩擦力.
• When Joan returned to work, the friction between them increased.
  琼回来工作后, 他们之间的摩擦加剧了.
• Friction acts on moving bodies and brings them to a stop.
  摩擦力作用于运动着的物体,并使其停止.
• Friction lowers the efficiency of a machine.
  摩擦减低机器的效率.
• In designing a machine it is necessary to reduce friction as much as possible.
  在设计一种机器时,必须尽可能减低摩擦.
• In most machines friction consumes effort, with the result that less work is got out than is put in.
  在大多数机器中,摩擦要消耗功, 以致造成输出的功要小于输入的功.
• Oil is put in machinery to reduce the friction.
  把油涂到机器上减少摩擦.
• Friction increases with increasing pretension.
  摩擦力随预加张力的增加而增加.
• Childbirth often were evident friction hemorrhage, as its vulnerability, will suture bleeding difficult.
  分娩时往往使疣体摩擦撕裂出血, 由于其组织脆弱, 会给缝扎止血带来困难.
• Problem: Friction locks cause throttle levers to stick.
  问题: 摩擦锁使节流阀杆卡住.
• Friction compels a body in motion to stop.
  磨擦迫使运动物体停止运动.
• The effects of friction on metallic rheology and mechanical parameters during plane strain compression were studied.
  研究了平面应变压缩过程中摩擦对金属流变规律以及力能参数的影响.
• The stiction and friction influencing the yield and reliability of MEMS are reviewed in this paper.
  文章评述了影响微电子机械系统(MEMS)成品率和可靠性的粘合力和摩擦力问题.
• The results show coefficients of form. FEM simulation of computer truly friction bound condition were provided.
  为计算机有限元模拟提供真实摩擦边界条件,为有限元模拟结果的可靠性奠定了坚实的基础.
• According to the work condition of pantograph slider, materials with improved friction wear performance was designed.
  根据受电弓滑板的工况条件, 设计了摩擦磨损性能较佳的受电弓滑板材料.
• Meanwhile, the friction and wear mechanism of composite coating is researched with modern analysis technologies . 4.
  同时运用现代分析技术,分析了复合膜的摩擦磨损机理.
• With their reduced mass, the cages cut the roller bearings'energy absorption and prevent sliding friction.
  其大规模减少的笼子里削减滚子轴承,能量吸收和防止摩擦.
• Neglecting friction and air resistance, the pendulum's mechanical energy is constant.
  忽略支点的摩擦和空气对摆的阻力, 摆的机械能为恒量.
• At the beginning of this thesis, there is a detailed introduction to friction model.
  本论文首先详细介绍了摩擦现象的数学模型.
• A new radial friction welding band technology on small shell was proposed.
  介绍了小口径炮弹弹带的摩擦焊技术.
• Main inducement is to get friction for a long time, shoe disagreement foot and sufficient deformation.
  主要诱因是长期受摩擦, 鞋不合脚和足畸形等.
• The ball bearings reduce the friction on the joint.
  滚珠可以减小结合处的摩擦.
• In order to completely overcome the friction, the backward hot extrusion is used.
  为了克服摩擦, 使用了反向热挤压.
• Friction usually results in unwanted heat that flows into the atmosphere and is wasted.
  摩擦导致产生不必要的热,这些热散失在大气中浪费掉了.
• Oil can reduce friction.
  润滑油能减小摩擦力.
• Friction acts on moving bodies and brings them to a stop.
  摩擦力作用于运动着的物体,并使其停止.
• Friction increases with increasing pretension.
  摩擦力随预加张力的增加而增加.
• The air molecules making up the earth's atmosphere create friction and tend to slow a rocket.
  组成地球大气层的空气分子会产生摩擦力,并会促使火箭减速.
• The forces due to friction are called frictional forces.
  由于摩擦而产生的力称之为摩擦力.
• The stiction and friction influencing the yield and reliability of MEMS are reviewed in this paper.
  文章评述了影响微电子机械系统(MEMS)成品率和可靠性的粘合力和摩擦力问题.
• Higher fiber to fiber friction.
  纤维间的摩擦力高.
• The algorithm gives a reference to the friction suppression in the force control system.
  此算法对力控制系统的摩擦力抑制具有一定的借鉴作用.
• That's because the friction of the wheels and track slowly drain energy away from the train.
  这是因为轮子与轨道的摩擦力会逐渐削弱车体的能量.
• The friction force between the specimen and jacket under passive confined pressure were further analyzed.
  同时分析了摩擦力效应对试样轴向应力应变的影响.
• In the ease of all motor vehicles, friction is essential in the operation of the brake.
  就机动车而言, 摩擦力对制动作用是必不可少的.
• Friction static friction are discussed.
  摩擦和静摩擦力进行了讨论.
• The flow stress obtained in micro compression test was modified to eliminate the influence of friction.
  结合微压缩实验讨论了流动应力的修正,即消除摩擦力对微压缩的影响.
• As a result, although there is minimal friction present, a lubricant is still absolutely essential.
  所以, 虽然还是存在极小的摩擦力, 但润滑剂绝对是至关重要的.
• This paper analyzes the effect of negative friction on piles axial force and its calculation.
  分析研究负摩擦力对桩轴力的影响及基桩负摩擦力的计算.
• Introduction any of various substances between sliding surfaces to reduce wear and friction.
  在滑动面间介入种种物质,以减少磨耗和摩擦力.
• The load is supported with the friction between the pile and the rock around.
  上部荷载主要通过桩基和周围岩土的摩擦力承担.
• Thus friction between two rough planks can be lessened if are made smooth.
  两块粗糙厚木板经过打磨后,它们之间的摩擦力会减小.
• The value of sliding friction depends on nature of the two surfaces which touch each other.
  华东摩擦力的大小取决于两接触面的自然属性.
• Robbins continues by writing that friction is useless unless the body direction of pull.
  罗宾斯在书中说道,如果身体没有受到牵引力的作用,那么摩擦力也是没有任何用处的.
• All working parts are usually oiled so that friction may be greatly reduced.
  全部活动部件通常都用油润滑,以大大减少摩擦力.
• Stem – stainless steel stem is precision ground for minimal packing friction during operation.
  阀杆–精密底面不锈钢阀杆,最大限度减少操作期间的填料摩擦力.
• The force which overcome to keep one surface moving over another in known as sliding friction.
  而保证一个平面沿着另一个平面相对移动的力称为滑动摩擦力.
• the coefficient of friction
  摩擦系数
• Friction between moving parts had caused the engine to overheat.
  活动部件的摩擦使发动机过热。
• The friction of the sheets against his skin was torture.
  被单摩擦着他的皮肤，简直像是酷刑。
• Oil can reduce friction.
  润滑油能减小摩擦力.
• When Joan returned to work, the friction between them increased.
  琼回来工作后, 他们之间的摩擦加剧了.
• Friction acts on moving bodies and brings them to a stop.
  摩擦力作用于运动着的物体,并使其停止.
• Friction lowers the efficiency of a machine.
  摩擦减低机器的效率.
• In designing a machine it is necessary to reduce friction as much as possible.
  在设计一种机器时,必须尽可能减低摩擦.
• In most machines friction consumes effort, with the result that less work is got out than is put in.
  在大多数机器中,摩擦要消耗功, 以致造成输出的功要小于输入的功.
• As far as we are concerned, these frictions are not of our own making [ have been imposed on us ].
  就我们来说, 这种 摩擦 是被动式的.
• Oil is put in machinery to reduce the friction.
  把油涂到机器上减少摩擦.
• Friction increases with increasing pretension.
  摩擦力随预加张力的增加而增加.
• Childbirth often were evident friction hemorrhage, as its vulnerability, will suture bleeding difficult.
  分娩时往往使疣体摩擦撕裂出血, 由于其组织脆弱, 会给缝扎止血带来困难.
• Problem: Friction locks cause throttle levers to stick.
  问题: 摩擦锁使节流阀杆卡住.
• The effects of friction on metallic rheology and mechanical parameters during plane strain compression were studied.
  研究了平面应变压缩过程中摩擦对金属流变规律以及力能参数的影响.
• The stiction and friction influencing the yield and reliability of MEMS are reviewed in this paper.
  文章评述了影响微电子机械系统(MEMS)成品率和可靠性的粘合力和摩擦力问题.
• The results show coefficients of form. FEM simulation of computer truly friction bound condition were provided.
  为计算机有限元模拟提供真实摩擦边界条件,为有限元模拟结果的可靠性奠定了坚实的基础.
• According to the work condition of pantograph slider, materials with improved friction wear performance was designed.
  根据受电弓滑板的工况条件, 设计了摩擦磨损性能较佳的受电弓滑板材料.
• Meanwhile, the friction and wear mechanism of composite coating is researched with modern analysis technologies . 4.
  同时运用现代分析技术,分析了复合膜的摩擦磨损机理.
• With their reduced mass, the cages cut the roller bearings'energy absorption and prevent sliding friction.
  其大规模减少的笼子里削减滚子轴承,能量吸收和防止摩擦.
• Neglecting friction and air resistance, the pendulum's mechanical energy is constant.
  忽略支点的摩擦和空气对摆的阻力, 摆的机械能为恒量.
• At the beginning of this thesis, there is a detailed introduction to friction model.
  本论文首先详细介绍了摩擦现象的数学模型.
• A new radial friction welding band technology on small shell was proposed.
  介绍了小口径炮弹弹带的摩擦焊技术.
• Main inducement is to get friction for a long time, shoe disagreement foot and sufficient deformation.
  主要诱因是长期受摩擦, 鞋不合脚和足畸形等.
• The ball bearings reduce the friction on the joint.
  滚珠可以减小结合处的摩擦.
• In order to completely overcome the friction, the backward hot extrusion is used.
  为了克服摩擦, 使用了反向热挤压.
• Friction usually results in unwanted heat that flows into the atmosphere and is wasted.
  摩擦导致产生不必要的热,这些热散失在大气中浪费掉了.
返回 friction