bonding strength

基本解释

• [纸] 结合强度；粘接强度；黏合强度

英汉例句

双语例句

• The high-strength bonding between diamond grit and steel matrices was realized by using a Ti-based filler alloy under controlled brazing conditions.
  采用钛基合金钎料，适当控制钎焊工艺，实现了金刚石与钢基体的高强度连接。
• With the constant high-temperature bonding-agent, the relationship was introduced between the quantity of bonding-agent and strength, porosity, porous diameter, infiltration.
  主要研究了高温粘结剂的加入量对制品的强度、平均孔径、孔隙率、渗透性等性能的影响。
• The results show that there is not any evidence of silver migration within LTCC construction, and conductor adhesive force, wire-bonding strength and insulation resistance are high.
  结果表明：基板内部的银导体不存在迁移现象，导体的附着力、键合强度以及基板的绝缘电阻等性能均比较理想。
  lib.nwnu.edu.cn

• bonding strength更多例句

词组短语

短语

• bonding g strength 胶合强度;胶接强度
• bonding bending strength 黏结抗折强度
• Bonding Media Strength 胶粘介质强度测量
• bonding -strength 结合强度
• shearing -bonding-strength 剪切胶合强度

• bonding strength更多词组

专业释义

能源科学技术

• 结合强度

  The results show that:the coating hasa unique with Vickers micro-hardness of 1 134HV0.1 and bonding strength more than 64 MPa.
  结果表明:该涂层具有独特的显微组织结构;涂层的维氏显微硬度达到了1 134HV0.1;结合强度超过64 MPa。

• 粘结强度

  After gaining the best activation patterns and the best content of coal gangue in cement mortar,the flexural strength ,compressive strength, bonding strength and consistency of the mortar were tested after adding fibrous brucite and water-reducing agent.
  在获得了煤矸石在水泥砂浆中最佳活化方式和最佳掺量后,在原掺煤矸石普通砂浆的基础上掺入水镁石纤维及减水剂进行不同灰矸比和不同灰砂比的水泥砂浆试验,除了抗折抗压强度测试外,还测试了砂浆的粘结强度和稠度。

• 粘接强度

  In this paper, a silver-epoxy adhesive die-attachment for experiment was prepared. Various experiment conditions for optimal bonding strength of the die-attachment were investigated by shear-mode experiments.
  制备了用于试验研究的银导电胶互联的基板-芯片试样,通过剪切模式破坏试验,研究了为获得银导电胶的最佳粘接强度的各种试验条件。

  医药科学

• 粘接强度

  The main method which judges whether an adhesive system works or not is the bonding strength test.
  粘接强度测试是评价一种牙本质粘接系统性能的重要方法。

• 粘结强度

  The shear bonding strength showed no significant difference between two groups,which met the clinical requirement.
  同时两组牙齿间托槽的抗剪粘结强度没有显著的差异性,且都能满足正畸临床应用中对托槽抗剪粘结强度的要求。

  机械工程

• 结合强度

  Culcination temperature and time influence the self-generated oxide layer, and then act on the coating’s quality and bonding strength.
  煅烧温度和时间通过对自生氧化层的作用影响涂层质量和结合强度。

• 胶合强度

  So did the 5-ply panels. Bonding tests showed that compressing method could improve 5% of panels’ bonding strength and percentage of wood failure.
  剪切实验表明，胶合板的胶合强度和木破率都由于单板的压缩均提高了5％左右。

• 胶合性能

化学

• 胶合强度

  When the temperature is 140°C, the bonding strength is 1.65MPa, which meets to the requirement of I-plywood.
  热压温度为140℃时，胶合强度为1.65MPa，达到Ⅰ类胶合板胶合强度要求。

• 附着力

  By modeling, the formulas for calculating the line peel-off intensity and the plane peel-off intensity were deduced, and the standard to estimate the bonding strength was put forward.
  最先引入了线剥离强度和面剥离强度两个附着力性能评价参数,通过建模推导出计算公式,从而给出了附着力检测评价标准。

  土木建筑工程

• 黏结强度

电子、通信与自动控制技术

• 键合强度

  That defects are mainly in interface of SDB affects bonding strength.
  硅键合片的缺陷主要集中在键合界面,键合强度受到很大影响。

  物理学

• 粘合强度
• 粘合强力
• 黏结强度

材料科学

• 粘合强度
• 黏结强度
• 黏合强度